Skip to content
Certification In Progress · Launching Q4 2026 Become a Distributor
Certification In Progress · Launching Q4 2026 Product Certifications Industries Blog About Contact Become a Distributor
Canada Mining Operations · explosion proof

Explosion-Proof Mobile Phone in Canada Mining Operations

A regional grouping rather than one site: Canada is a major producer of nickel, copper, potash and uranium, and the Sudbury Basin in Ontario is one of the world's largest nickel and copper ore suppliers. Where flammable gas exceeds 0.8 percent near electrical equipment or diesel engines the area must be tested at least every eight hours, and a methanometer alarm is required at longwall faces where gas may reach 1.25 percent. If you are specifying an explosion proof mobile phone for Canadian mining regions, this page covers the markings, the approvals and the current certification status of the IS-04Z1.

Pre-launch · certification in progress · Launching Q4 2026

SAMS IS-04Z1 intrinsically safe smartphone for Canada Mining Operations, front view
Marking targetEx ib IIC T4Intrinsic safety, Zone 1 / 21 design target · certification in progress
AvailabilityQ4 2026via authorised distributors
Search topicexplosion proof
DeviceMobile Phone
RouteSpecification
WhereCanada Mining Operations

Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for Canadian mining regions: pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.

Current position: certification in progress, nothing issued, launch targeted for Q4 2026. A buyer's engineering review is separate from the certificate. Certification status. Place facts reviewed October 2026.

At a glance · explosion proof

Checklist: explosion proof mobile phone for Canadian mining regions

Specification checklist against the IS-04Z1 today
CheckWhat to look forIS-04Z1 today
Protection conceptFlameproof (Ex d) or intrinsic safety (Ex i)Intrinsic safety, level ib
Zone suitabilityZone 1 gas and Zone 21 dustDesign target for Zone 1 and 21
CertificateNumber, issuing body and schedule of conditionsIn progress; not issued
Where it appliesCanadian mining regions: Underground mine workings, Ore processing plants, Fuel storageClassified by the site operator
Product · Canada Mining Operations

The product behind this search: the SAMS IS-04Z1.

SAMS IS-04Z1 explosion proof mobile phone, front view

SAMS IS-04Z1

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Canada Mining Operations. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.

  • IP68 sealed
  • 4,000 mAh battery
  • 50 MP camera
  • Android 16
  • Zone 1 / Zone 21 design target
The site · Canadian mining regions

Canadian mining regions: where the IS-04Z1 would work

Who operates there and which kinds of classified area a handset would meet, from the SAMS site research.

Operators and companies on site

  • Vale (Sudbury Basin)

Classified areas to expect

  • Underground mine workings
  • Ore processing plants
  • Fuel storage
  • Explosives storage
Local conditions · Canadian mining regions

Conditions in Canadian mining regions that affect handheld equipment

Underground access

Equipment taken underground generally has to suit the mine's hazard classification and may need approval by the mine's own electrical or safety department.

Cold-climate working

Winters in much of mining Canada are cold enough that battery performance, glove use on touchscreens and condensation are practical concerns.

Field notes · Canadian mining regions

More about Canadian mining regions that matters for portable equipment

Canadian mining regions: rules and approvals

Underground diesel engines must have exhaust sampled at least monthly, and an engine is removed from service if exhaust carbon monoxide exceeds 2,000 ppm, a reminder of how closely air quality is controlled in coal mines.

Canadian mining regions: projects and investment

Mining contributed about 7.9 percent of Canada's GDP in 2021, roughly 156.5 billion Canadian dollars, split across extraction, services and manufacturing.

Canadian mining regions: background

Industrial-scale mining began in the 18th century, with an iron mine at Forges du Saint-Maurice (1738 to 1883) and copper at Bruce Mines, Ontario from 1848, so many sites are old and complex.

Canadian mining regions: industry on the ground

Canada was the world's largest potash producer in 2019 and a top-ten producer of gold, nickel, platinum, iron ore, titanium, niobium, sulphur, molybdenum and cobalt.

The term · explosion proof

What “explosion proof” means for a smartphone

“Explosion proof” is the phrase most buyers use for equipment that may be taken into a classified hazardous area. Strictly, it covers several protection concepts: a flameproof enclosure (Ex d) contains an internal explosion, while intrinsic safety (Ex i) limits electrical energy so that an ignition cannot start. Phones are normally intrinsically safe, because a flameproof handset would be too heavy to carry all shift.

The IS-04Z1 uses intrinsic safety, with a marking target of Ex ib IIC T4, and is designed for Zone 1 and Zone 21. It is pre-launch, certification is in progress and no certificate has been issued.

In Canadian mining regions. Underground, explosion-proof is a loose phrase. Flameproof Ex d enclosures suit fixed electrical gear, while a phone depends on intrinsic safety. Fuel storage and explosives stores are controlled areas too. Which protection concept is acceptable underground depends on the mine's hazard classification and its electrical or safety department.

The route · specification

Specifying an explosion proof mobile phone for Canada Mining Operations

A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.

Check on the paper

Marking
Equipment group, category, protection concept, gas group and temperature class, matched to the area drawing.
Certificate and schedule
A certificate number, issuing body and the schedule of conditions, not a brochure claim.
Standards edition
The IEC 60079 or national standard edition the certificate was issued against.

Check for the IS-04Z1

Marking target
II 2 G Ex ib IIC T4: a target, not yet a certificate.
Certificate status
IECEx, ATEX, UKEX and NEC 500 in progress; none issued.
Operator approval
Separate from the certificate and handled with the site operator.
Questions · Canada Mining Operations

Frequently asked questions

Can we buy an explosion proof mobile phone in Canada Mining Operations today?

Not yet. The IS-04Z1 is pre-launch and its certification is still in progress ahead of a Q4 2026 launch. No unit goes into a classified area before the certificate covering it exists. The datasheet, the certification schedule and safe-area evaluation units are available now.

What does an explosion proof mobile phone in Canada Mining Operations cost?

No price is published. While certification is in progress there is no list price and no committed lead time, and a supplier quoting a firm figure for an uncertified Ex handset is promising something it cannot stand behind. Indicative pre-launch pricing is issued in writing against a stated quantity and site.

Is the IS-04Z1 explosion proof or intrinsically safe?

It is intrinsically safe (marking target Ex ib IIC T4), which is the usual way to make a phone for hazardous areas. It is not a flameproof (Ex d) design, and certification is still in progress.

Which areas at Canadian mining regions would use it?

Likely candidates are underground mine workings, ore processing plants, fuel storage, explosives storage. Which areas are classified, and to what zone, is set by the site operator's own area classification drawings.

Is intrinsically safe the same as explosion proof?

Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.

Who regulates mine safety in Canada?

Mining is mostly provincial, so each province enforces its own occupational health and safety rules; federal regulations such as the coal mining ones apply to federal jurisdictions. Confirm which authority and which Ex marking scheme the mine accepts.

Which Canadian mines have gas hazards requiring Ex equipment?

Underground coal mines are the clearest case because methane is a flammable gas. Some hard-rock operations have fuel stores, explosives areas or battery charging bays that are classified, so confirm with the mine's hazard assessment which areas need certified devices.

Who regulates equipment in a Canadian mine?

Mine safety is regulated province by province. Ontario, for example, has Regulation 854 (Mines and Mining Plants) under the Occupational Health and Safety Act, with a part on electrical equipment. Other provinces have their own rules, and each mine may add requirements. Check the applicable provincial regulation and the operator's procedure.

Enquiry · Canadian mining regions

Ask about the IS-04Z1 for Canadian mining regions, Canada

Send the site, zone and gas group and roughly how many handsets. We reply by email with the datasheet and the certification schedule.

Enquiry · Canadian mining regions

Please enter your name.
Please enter your company name.
Enter a valid email address.
Please enter your target market.
Please select one.

Launching Q4 2026

Planning for Canada Mining Operations?

Name the site and the operator and we will send what is available before launch.