Joffre site
The site has five NOVA manufacturing facilities: three for ethylene and two for polyethylene.
Red Deer is a central Alberta city, and NOVA Chemicals' Joffre complex lies nearby. It is one of the largest ethylene and polyethylene complexes in the world, with flammable gas and liquid handling throughout. If you are specifying an intrinsically safe smartphone for Red Deer and Joffre industrial area, this page covers the markings, the approvals and the current certification status of the IS-04Z1.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for Red Deer and Joffre industrial area: pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.
Current position: certification in progress, nothing issued, launch targeted for Q4 2026. A buyer's engineering review is separate from the certificate. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Level of protection | ia, ib or ic matched to the zone | ib, for Zone 1 |
| Entity parameters | Uo, Io and Po within the device limits | Published with the certificate |
| Accessories | Chargers and cases certified with the device | Defined at certification |
| Where it applies | Red Deer and Joffre industrial area: Ethylene plants, Polyethylene plants, Ethane feedstock handling | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Red Deer Industrial. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
Who operates there and which kinds of classified area a handset would meet, from the SAMS site research.
The site has five NOVA manufacturing facilities: three for ethylene and two for polyethylene.
A 431 kilotonne per year linear low density polyethylene unit expanded the site's polyethylene capacity by about 40 per cent.
Red Deer expanded rapidly after major oil discoveries in Alberta in the late 1940s and became a centre for oil and gas and related industries, including the Joffre Cogeneration Plant.
Joffre Cogeneration is a 480 MW gas-fired combined-cycle plant commissioned in 2001 that supplies power, water and steam to the NOVA site and electricity to Alberta's grid.
The 2021 census counted 100,844 people in Red Deer, now classed as a census metropolitan area, giving the plants a local labour pool.
Red Deer has a humid continental climate with a semi-arid influence from its position in Palliser's Triangle, so summers can be warm and dry and winters cold.
Intrinsic safety limits the electrical and thermal energy in a circuit so that neither a spark nor a hot surface can ignite a gas or dust atmosphere, even when a fault occurs. The ib level, used for Zone 1, tolerates one fault. It is the usual way to make a handheld device that a worker carries continuously through a hazardous area.
The IS-04Z1 is designed on this principle for Zone 1 and Zone 21 (marking target II 2 G Ex ib IIC T4). Intrinsic safety is a design basis, not a certificate: certification is in progress and none has been issued yet.
In Red Deer and Joffre industrial area. Joffre has five NOVA manufacturing facilities: three for ethylene and two for polyethylene. Operators and inspectors cover large units and storage areas on rounds. A handheld intrinsically safe device supports checklists and photos in situ. Permits and isolations remain under the plant's own system.
A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.
Not today. Until the certificates are issued the IS-04Z1 stays out of classified areas, and until launch there is nothing to purchase. You can ask for the datasheet and the certification schedule, or book a safe-area evaluation unit.
No price is published. While certification is in progress there is no list price and no committed lead time, and a supplier quoting a firm figure for an uncertified Ex handset is promising something it cannot stand behind. Indicative pre-launch pricing is issued in writing against a stated quantity and site.
The circuits are designed to limit energy so a spark or hot surface cannot ignite a gas or dust atmosphere, even with one fault (level ib, Zone 1). Certification of that design is in progress.
Likely candidates are ethylene plants, polyethylene plants, ethane feedstock handling, hydrocarbon storage. Which areas are classified, and to what zone, is set by the site operator's own area classification drawings.
Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.
Typically cracker furnaces, ethylene and hydrogen areas, polymer reactors and powder handling with dust risks. Gas groups can reach IIB or IIC for hydrogen, and dust zones may apply. Confirm area classification drawings with the operator.
The site reports up to 1,200 contractors during turnarounds, so induction, permits and gate checks are structured. Confirm the contractor safety process and approved-device list with NOVA Chemicals before mobilising.
Ethylene is commonly treated as a more demanding gas than typical fuels, which is why a marking check at an ethylene plant looks closely at the gas group. The IS-04Z1 target marking includes IIC. The plant operator sets the gas group for each area, so request that data before any evaluation.
Related guides for Red Deer Industrial and for Canada.
Tell us what you need to equip and where. The SAMS team answers by email with the datasheet and where each certification route stands.
Name the site and the operator and we will send what is available before launch.