Dispersed sites
The play extends through areas around Fort St. John and Dawson Creek in British Columbia and into Alberta, so facilities are spread over a wide area.
The Montney Formation covers about 130,000 square kilometres of British Columbia and Alberta and is a major shale gas and tight oil resource. Wellpads, compressor stations and gas plants across it contain classified areas. If you are specifying an intrinsically safe smartphone for Montney gas play, this page covers the markings, the approvals and the current certification status of the IS-04Z1.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for Montney gas play: pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.
Current position: certification in progress, nothing issued, launch targeted for Q4 2026. An operator's own vendor approval is a separate step. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Level of protection | ia, ib or ic matched to the zone | ib, for Zone 1 |
| Entity parameters | Uo, Io and Po within the device limits | Published with the certificate |
| Accessories | Chargers and cases certified with the device | Defined at certification |
| Where it applies | Montney gas play: Wellpads and wellheads, Gas processing plants, Compressor stations | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Montney Gas Field. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
Who operates there and which kinds of classified area a handset would meet, from the SAMS site research.
The play extends through areas around Fort St. John and Dawson Creek in British Columbia and into Alberta, so facilities are spread over a wide area.
ARC Resources has described Attachie near Fort St. John producing more than 30,000 barrels of oil equivalent per day, including condensate.
A 2013 joint study by the National Energy Board, the BC Oil and Gas Commission and the Alberta Energy Regulator assessed the formation, and gas is produced in both provinces, so operators work under two regimes.
In northeast British Columbia some wells contain hydrogen sulphide, which makes gas sour, flammable and potentially deadly if inhaled, and Geoscience BC research maps where it occurs in unconventional reservoirs.
The Montney is a Lower Triassic unit of dolomitic siltstone and sandstone up to about 280 m thick, which supports long horizontal wells.
The Montney Formation was first described in 1962 from Texaco's Buick Creek No. 7 well, drilled 41 km north of Fort St. John immediately east of the Alaska Highway.
Intrinsic safety limits the electrical and thermal energy in a circuit so that neither a spark nor a hot surface can ignite a gas or dust atmosphere, even when a fault occurs. The ib level, used for Zone 1, tolerates one fault. It is the usual way to make a handheld device that a worker carries continuously through a hazardous area.
The IS-04Z1 is designed on this principle for Zone 1 and Zone 21 (marking target II 2 G Ex ib IIC T4). Intrinsic safety is a design basis, not a certificate: certification is in progress and none has been issued yet.
In Montney gas play. Crews move between widely spread wellpads and compressor stations around Fort St. John and Dawson Creek and into Alberta. A handheld intrinsically safe device lets them log readings, take photos and check procedures on site. It does not replace permits or gas testing, which the operator controls.
A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.
Not yet. The IS-04Z1 is pre-launch and its certification is still in progress ahead of a Q4 2026 launch. No unit goes into a classified area before the certificate covering it exists. The datasheet, the certification schedule and safe-area evaluation units are available now.
There is no list price yet. SAMS gives indicative pre-launch pricing in writing, against a stated quantity and site, and does not commit to a lead time before certification completes.
The circuits are designed to limit energy so a spark or hot surface cannot ignite a gas or dust atmosphere, even with one fault (level ib, Zone 1). Certification of that design is in progress.
Likely candidates are wellpads and wellheads, gas processing plants, compressor stations, condensate handling. Which areas are classified, and to what zone, is set by the site operator's own area classification drawings.
Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.
Hydrogen sulphide is a toxic hazard rather than an Ex rating, but sour sites add gas detection, breathing apparatus and rules for devices. Confirm requirements with the operator's induction team and ensure your device meets zone and gas group needs.
Typically wellpads, gas gathering, compressor stations and gas plants with flammable natural gas, and some sites with condensate or sour gas. Classified areas vary by facility, so request the operator's classification drawing before bringing equipment.
Yes, gas from the Montney supplies LNG Canada through the Coastal GasLink pipeline. That link does not change the area classification at a wellpad, which the producing operator decides. A handset would still need to match the zone, gas group and temperature class assigned for that location. Ask the operator for the area data.
Other guides for Montney Gas Field, other places in Canada, and the pages behind them.
Share the site details and quantity. You will get the datasheet and the certification schedule back by email; pricing is indicative only until launch.
Name the site and the operator and we will send what is available before launch.