Operating refineries
Reported capacities are roughly 270,000 barrels a day at ExxonMobil's Fawley on Southampton Water, about 296,000 at Stanlow in Cheshire and about 221,000 at Phillips 66's Humber site in North Lincolnshire.
England hosts three of the UK's four operating refineries, Fawley, Stanlow and Humber, with Pembroke in Wales the fourth. Classified areas also occur at fuel terminals, gas networks and chemical sites. Lindsey stopped refining in 2025. If you are specifying an ATEX and IECEx mobile phone for England, this page covers the markings, the approvals and the current certification status of the IS-04Z1.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for England: pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.
Where things stand: the IS-04Z1 has not launched, and none of its four certification routes has produced a certificate yet. A buyer's engineering review is separate from the certificate. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Marking | II 2 G Ex ib IIC T4 on the rating plate | Design target; not yet marked |
| EU-type examination certificate | Notified body number and certificate ID | In progress with TÜV; not issued |
| IECEx certificate of conformity | Number listed on the IECEx online register | In progress; not issued |
| Where it applies | England: Refinery process units, Fuel terminals and tank farms, Marine oil jetties | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in England. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
A short profile of the site and the kinds of classified area that matter for portable equipment.
Reported capacities are roughly 270,000 barrels a day at ExxonMobil's Fawley on Southampton Water, about 296,000 at Stanlow in Cheshire and about 221,000 at Phillips 66's Humber site in North Lincolnshire.
Lindsey closed in 2025 after owner Prax became insolvent; Phillips 66 agreed in January 2026 to acquire assets but said it will not restart it as a standalone refinery.
COMAH 2015 is enforced by a joint Competent Authority: HSE, or the Office for Nuclear Regulation for nuclear sites, working with the Environment Agency in England, Natural Resources Wales or SEPA in Scotland.
Major-hazard sites fall under the Control of Major Accident Hazards Regulations 2015, with HSE publishing guidance and public information on establishments covered, so top-tier and lower-tier sites follow a further regime.
Employers must identify and classify areas where explosive atmospheres may occur and avoid ignition sources, for example from unprotected equipment, in those areas.
HSE lists dangerous substances as including solvents, paints, varnishes, flammable gases such as LPG, dusts from machining, sanding and foodstuffs, pressurised gases and substances corrosive to metal.
ATEX is the European legal framework for equipment used in explosive atmospheres (Directive 2014/34/EU). IECEx is the international certification scheme built on the IEC 60079 standards. Buyers outside Europe often ask for both: an IECEx certificate is the technical evidence most national regimes build on, while ATEX is the legal route into the European market.
For the IS-04Z1 both routes are in progress with TÜV in Germany and neither certificate has been issued. The marking target is II 2 G Ex ib IIC T4: equipment Group II (surface industry), Category 2 (Zone 1 gas), protection concept ib (intrinsic safety), gas group IIC and temperature class T4.
In England. Across England, an HSE or procurement reviewer typically expects equipment evidence matched to the employer's DSEAR assessment. Refinery and terminal operators at Fawley, Stanlow and Humber also employ international contractors who carry ATEX or IECEx paperwork. A dual route is designed to serve both. Both certifications are in progress for SAMS and none has been issued.
A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.
Not today. Until the certificates are issued the IS-04Z1 stays out of classified areas, and until launch there is nothing to purchase. You can ask for the datasheet and the certification schedule, or book a safe-area evaluation unit.
SAMS has not published a price. Any figure you are offered for an uncertified Ex phone should be treated with caution; written indicative pricing is available for a defined quantity and site.
Not yet. Both routes are in progress with TÜV in Germany and no certificate has been issued. Any listing that says otherwise is wrong.
Likely candidates are refinery process units, fuel terminals and tank farms, marine oil jetties, petrochemical units. Which areas are classified, and to what zone, is set by the site operator's own area classification drawings.
Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.
The Health and Safety Executive, and in some premises local authorities, enforce DSEAR. They expect employers to carry out a risk assessment, classify areas and control ignition sources. Ask your client which assessments and records apply to your work.
Yes. HSE lists dusts from machining, sanding and foodstuffs among dangerous substances, so combustible dust areas can be classified in the same way as gas areas. Check whether your task is near flour, wood, metal or grain handling and ask for the zone classification.
England hosts three of the UK's four operating refineries: Fawley, Stanlow and Humber. Fuel terminals, gas networks and chemical sites also contain classified areas. Lindsey stopped refining in 2025. Each operator assesses its own zones, so confirm requirements with the site operator for the specific site.
Other guides for England, other places in United Kingdom, and the pages behind them.
Send the site, zone and gas group and roughly how many handsets. We reply by email with the datasheet and the certification schedule.
Tell us the zone, gas group and operator. We will send the datasheet and the certification schedule.