Dispersed sites
The play extends through areas around Fort St. John and Dawson Creek in British Columbia and into Alberta, so facilities are spread over a wide area.
The Montney Formation covers about 130,000 square kilometres of British Columbia and Alberta and is a major shale gas and tight oil resource. Wellpads, compressor stations and gas plants across it contain classified areas. This page explains what to look for in an industrial mobile phone for Montney gas play, and where the IS-04Z1 stands against that list today.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for Montney gas play: pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.
Status: pre-launch. IECEx, ATEX, UKEX and NEC 500 certification is in progress and no certificate has been issued; launch is planned for Q4 2026. Operator approval runs on its own timeline. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Ingress protection | IP rating for dust and water | IP68 design |
| Fleet management | EMM and MDM support | Android 16 with EMM and MDM |
| Explosion protection | A separate certificate and marking | In progress; not issued |
| Where it applies | Montney gas play: Wellpads and wellheads, Gas processing plants, Compressor stations | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Montney Gas Field. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
The companies on site and the hazardous-area types a handset is likely to meet there.
The play extends through areas around Fort St. John and Dawson Creek in British Columbia and into Alberta, so facilities are spread over a wide area.
ARC Resources has described Attachie near Fort St. John producing more than 30,000 barrels of oil equivalent per day, including condensate.
A 2013 joint study by the National Energy Board, the BC Oil and Gas Commission and the Alberta Energy Regulator assessed the formation, and gas is produced in both provinces, so operators work under two regimes.
In northeast British Columbia some wells contain hydrogen sulphide, which makes gas sour, flammable and potentially deadly if inhaled, and Geoscience BC research maps where it occurs in unconventional reservoirs.
The Montney is a Lower Triassic unit of dolomitic siltstone and sandstone up to about 280 m thick, which supports long horizontal wells.
The Montney Formation was first described in 1962 from Texaco's Buick Creek No. 7 well, drilled 41 km north of Fort St. John immediately east of the Alaska Highway.
“Industrial” describes a phone built for plant conditions: sealed, drop-resistant and manageable at fleet scale through Android Enterprise. It does not by itself mean the phone may enter a classified area. Only a device with a valid explosion-protection certificate and marking may do that.
The IS-04Z1 is designed to be both an industrial Android phone (IP68, 4,000 mAh battery, 50 MP camera, Android 16 with EMM and MDM support) and an intrinsically safe one. Its explosion-protection certificates are in progress and have not been issued.
In Montney gas play. Because facilities are dispersed across the play, a fleet of devices may be used by field teams who rarely visit an office. EMM or MDM enrolment, including remote updates, is valuable. The IS-04Z1 is designed for Android 16 management. Charging would be in safe areas, and network coverage should be tested.
A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.
Not today. Until the certificates are issued the IS-04Z1 stays out of classified areas, and until launch there is nothing to purchase. You can ask for the datasheet and the certification schedule, or book a safe-area evaluation unit.
There is no list price yet. SAMS gives indicative pre-launch pricing in writing, against a stated quantity and site, and does not commit to a lead time before certification completes.
Yes by design: IP68 sealing, a 4,000 mAh battery, a 50 MP camera and Android 16 with EMM and MDM support. The explosion-protection certificates are separate and still in progress.
Likely candidates are wellpads and wellheads, gas processing plants, compressor stations, condensate handling. Which areas are classified, and to what zone, is set by the site operator's own area classification drawings.
Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.
Hydrogen sulphide is a toxic hazard rather than an Ex rating, but sour sites add gas detection, breathing apparatus and rules for devices. Confirm requirements with the operator's induction team and ensure your device meets zone and gas group needs.
Typically wellpads, gas gathering, compressor stations and gas plants with flammable natural gas, and some sites with condensate or sour gas. Classified areas vary by facility, so request the operator's classification drawing before bringing equipment.
Yes, gas from the Montney supplies LNG Canada through the Coastal GasLink pipeline. That link does not change the area classification at a wellpad, which the producing operator decides. A handset would still need to match the zone, gas group and temperature class assigned for that location. Ask the operator for the area data.
Related guides for Montney Gas Field and for Canada.
Tell us what you need to equip and where. The SAMS team answers by email with the datasheet and where each certification route stands.
Send the zone and gas group of your site and we will reply with the datasheet and schedule.