Expansion plans
Further trains have been proposed as a possible second phase, so construction and commissioning activity may continue.
LNG carriers sail up and down the Douglas Channel to the port of Kitimat to load, mainly for Asian markets, using a new carrier terminal connected to the liquefaction and storage plant. Gas handling, liquefaction and ship loading create Zone 1 and Zone 2 areas. If you are specifying an IECEx smartphone for LNG Canada, Kitimat, this page covers the markings, the approvals and the current certification status of the IS-04Z1.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for LNG Canada, Kitimat: pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.
Current position: certification in progress, nothing issued, launch targeted for Q4 2026. Operator approval runs on its own timeline. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Certificate of conformity | Number checkable on the IECEx online register | In progress; not issued |
| Standards edition | The IEC 60079 edition the certificate cites | Stated on the certificate when issued |
| Schedule of conditions | Limits of use, batteries and accessories | Published with the certificate |
| Where it applies | LNG Canada, Kitimat: LNG liquefaction trains, LNG storage and loading, Gas receipt from pipeline | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Kitimat LNG. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
The companies on site and the hazardous-area types a handset is likely to meet there.
Further trains have been proposed as a possible second phase, so construction and commissioning activity may continue.
The plant produced its first LNG and shipped its first cargo in June 2025; the second train was reported to begin operating in November 2025.
LNG Canada is a joint venture of Shell (40 percent), Petronas (25), PetroChina (15), Mitsubishi (15) and KOGAS (5), with a total investment estimated at about 40 billion dollars approved on 1 October 2018.
Kitimat was planned and built by Alcan in the 1950s, and Rio Tinto's aluminium smelter is still the main employer; other local activity includes engineering, metal fabrication and imports of methanol and condensate.
The terminal was designed with two liquefaction trains totalling 14 million tonnes per year, with the option of two more trains to raise capacity to 26 million tonnes per year.
Engineering and construction supervision was awarded to a joint venture of JGC Corporation of Japan and Fluor Corporation, called JGC Fluor, which shaped the contractor structure on site.
IECEx is the international scheme for certifying equipment used in explosive atmospheres. A certificate of conformity is issued by an accredited certification body against a specific edition of the IEC 60079 standards and carries a schedule of conditions of safe use. It is not a legal requirement in most countries on its own, but many national schemes accept it as the technical basis.
The IECEx certificate for the IS-04Z1 is in progress and has not been issued. The marking target is Ex ib IIC T4, the intrinsic safety concept for Zone 1 gas with the hardest gas group (IIC) and a 135 °C temperature class.
In LNG Canada, Kitimat. With shareholders and contractors from several countries, LNG Canada is the kind of project where IECEx documentation is widely understood. A certificate of conformity and schedule of conditions would be the reference set. The IS-04Z1 is designed for the IECEx route, with certification in progress and no certificate issued.
A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.
Not yet. The IS-04Z1 is pre-launch and its certification is still in progress ahead of a Q4 2026 launch. No unit goes into a classified area before the certificate covering it exists. The datasheet, the certification schedule and safe-area evaluation units are available now.
SAMS has not published a price. Any figure you are offered for an uncertified Ex phone should be treated with caution; written indicative pricing is available for a defined quantity and site.
No. The IECEx certificate is in progress and has not been issued. SAMS will publish the number when it exists.
Likely candidates are lng liquefaction trains, lng storage and loading, gas receipt from pipeline, marine loading jetty. Which areas are classified, and to what zone, is set by the site operator's own area classification drawings.
Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.
Typically liquefaction trains, refrigerant (propane, ethylene or mixed refrigerant) storage, LNG tanks and loading, flare and gas treatment areas. Gas groups include methane (IIA) and possibly propane or ethylene. Confirm zone drawings with the plant operator.
LNG plants use cryogenic fluids, so cold surfaces, ice and moisture are concerns around process areas. Choose sealed devices and confirm operator guidance on temperature class and ingress protection.
Gas arrives from the Montney Formation through the 670 km Coastal GasLink pipeline, built and operated by TC Energy. A device used at gas receipt would be in a hydrocarbon gas area, so the operator's classification and gas group data should be reviewed. Ask the plant owner for the relevant records.
Other guides for Kitimat LNG, other places in Canada, and the pages behind them.
Tell us what you need to equip and where. The SAMS team answers by email with the datasheet and where each certification route stands.
Name the site and the operator and we will send what is available before launch.