Canada: rules and approvals
Radio and wireless devices sold in Canada need ISED certification against the Radio Standards Specifications, such as RSS-247 for Wi-Fi and Bluetooth and RSS-Gen for general requirements and labelling.
The IS-04Z1 is an Ex phone for people working inside classified areas at Canadian oil sands plants, gas plants, refineries and offshore platforms. If you are specifying an IECEx smartphone for Canada, this page covers the markings, the approvals and the current certification status of the IS-04Z1.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for Canada: pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.
Status: pre-launch. IECEx, ATEX, UKEX and NEC 500 certification is in progress and no certificate has been issued; launch is planned for Q4 2026. An operator's own vendor approval is a separate step. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Certificate of conformity | Number checkable on the IECEx online register | In progress; not issued |
| Standards edition | The IEC 60079 edition the certificate cites | Stated on the certificate when issued |
| Schedule of conditions | Limits of use, batteries and accessories | Published with the certificate |
| Where it applies | Canada: Athabasca oil sands, Cold Lake and the Lakeland, Alberta Industrial Heartland | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Canada. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
The classified areas, operators and sites below are the ones covered in the SAMS Canada market guide.
Radio and wireless devices sold in Canada need ISED certification against the Radio Standards Specifications, such as RSS-247 for Wi-Fi and Bluetooth and RSS-Gen for general requirements and labelling.
Fort McMurray averages minus 17.2 degrees Celsius in January, with a recorded low of minus 53.3 degrees, so batteries, touchscreens and enclosures need to work in deep cold.
Canada also accepts field certification for custom-made or low-volume equipment, evaluated at the installation site, which is similar to unit verification under the IECEx and ATEX systems.
Hazardous locations in Canada fall under Section 18 of the Canadian Electrical Code Part I, which uses the Zone system, while the older Class and Division rules are kept in Annex J for existing installations.
IECEx is the international scheme for certifying equipment used in explosive atmospheres. A certificate of conformity is issued by an accredited certification body against a specific edition of the IEC 60079 standards and carries a schedule of conditions of safe use. It is not a legal requirement in most countries on its own, but many national schemes accept it as the technical basis.
The IECEx certificate for the IS-04Z1 is in progress and has not been issued. The marking target is Ex ib IIC T4, the intrinsic safety concept for Zone 1 gas with the hardest gas group (IIC) and a 135 °C temperature class.
In Canada. IECEx is the scheme visiting international operators and EPCs may bring to Canada, from Kitimat LNG to the Grand Banks, but Rule 18-050 requires equipment certified by a body accredited by the Standards Council of Canada. The certificate of conformity and schedule of conditions would be read alongside that. Nothing has been issued yet.
A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.
Not today. Until the certificates are issued the IS-04Z1 stays out of classified areas, and until launch there is nothing to purchase. You can ask for the datasheet and the certification schedule, or book a safe-area evaluation unit.
SAMS has not published a price. Any figure you are offered for an uncertified Ex phone should be treated with caution; written indicative pricing is available for a defined quantity and site.
No. The IECEx certificate is in progress and has not been issued. SAMS will publish the number when it exists.
The market guide for Canada covers Athabasca oil sands, Cold Lake and the Lakeland, Alberta Industrial Heartland, Montney and Duvernay, among others. Site-level pages are linked below.
Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.
Hazardous-location electrical equipment in Canada is generally expected to carry certification from a Standards Council of Canada accredited body, and IECEx or ATEX certificates are not accepted as a substitute, although they can speed the evaluation. Confirm the required marking with the site operator and a Canadian certification body.
Fort McMurray averages about minus 17 degrees Celsius in January and has seen extremes below minus 50, so check the datasheet's operating and charging temperature range, battery behaviour in cold, and glove-friendly controls. Confirm any site cold-weather procedures with the operator before deployment.
Every battery gives up capacity in the cold, and the 4,000 mAh cell is sized for a normal shift, not extreme cold. Unless a certificate says otherwise, hazardous area equipment is assessed for minus 20 to plus 40 degrees Celsius, and the marked range will be published when the certificate issues. Check it first.
More on Canada, and on other places in Canada.
Tell us what you need to equip and where. The SAMS team answers by email with the datasheet and where each certification route stands.
Tell us the zone, gas group and operator. We will send the datasheet and the certification schedule.