Skip to content
Certification In Progress · Launching Q4 2026 Become a Distributor
Certification In Progress · Launching Q4 2026 Product Certifications Industries Blog About Contact Become a Distributor
Finland · hazardous area

Hazardous Area Mobile Phone Supplier in Finland

The IS-04Z1 is an intrinsically safe Android handset designed for Zone 1 and Zone 21, built for the refinery and polymer plants at Kilpilahti, the metal and chemical parks on the Bothnian coast and the mill and mine sites where a winter round is measured in kilometres. This page sets out how a hazardous area mobile phone supply route to Finland will work for the IS-04Z1, and what is and is not available before launch.

Pre-launch · certification in progress · Launching Q4 2026

SAMS IS-04Z1 intrinsically safe smartphone for Finland, front view
Marking targetEx ib IIC T4Intrinsic safety, Zone 1 / 21 design target · certification in progress
AvailabilityQ4 2026via authorised distributors
Search topichazardous area
DeviceMobile Phone
RouteSupply
WhereFinland

Short answer. A hazardous area mobile phone for Finland cannot be bought yet: the SAMS IS-04Z1 is pre-launch (certification in progress, no certificate issued), and the datasheet, certification schedule and safe-area evaluation units are available now.

Where things stand: the IS-04Z1 has not launched, and none of its four certification routes has produced a certificate yet. Operator approval runs on its own timeline. Certification status. Place facts reviewed October 2026.

At a glance · hazardous area

Checklist: hazardous area mobile phone for Finland

Specification checklist against the IS-04Z1 today
CheckWhat to look forIS-04Z1 today
Zone0, 1 or 2 for gas; 20, 21 or 22 for dustDesigned for Zone 1 and Zone 21
Gas groupIIA, IIB or IICIIC (target)
Area drawingThe operator's own classification drawingDecided by the site operator
Where it appliesFinland: Sotkamo, Äänekoski, Kilpilahti, PorvooClassified by the site operator
Product · Finland

The product behind this search: the SAMS IS-04Z1.

SAMS IS-04Z1 explosion proof mobile phone, front view

SAMS IS-04Z1

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Finland. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.

  • IP68 sealed
  • 4,000 mAh battery
  • 50 MP camera
  • Android 16
  • Zone 1 / Zone 21 design target
The market · Finland

Where this applies in Finland

The classified areas, operators and sites below are the ones covered in the SAMS Finland market guide.

Operators, EPCs and contractors

Neste
Porvoo refinery and renewable fuel production at Kilpilahti and Naantali.
Borealis Polymers
Cracker and polyolefin production inside the Kilpilahti area.
Kemira
Process and pulp chemicals at Oulu, Joutseno and Äetsä.
Terrafame
Nickel, zinc and battery chemical production at Sotkamo in Kainuu.
Boliden Kokkola
Zinc smelting and processing in the Kokkola industrial park.
Yara Suomi
Fertiliser and nitrogen chemical plants at Uusikaupunki and Siilinjärvi.

Industrial areas and sites

Kilpilahti, Porvoo
Refinery, cracker, polymer plants and chemical park behind one perimeter.
Naantali
Coastal refining and terminal operations near Turku.
Kokkola
Large chemical and metals industrial park on the Bothnian coast.
Harjavalta
Copper, nickel and battery material processing in Satakunta.
Sotkamo
Metal and battery chemical production in the Kainuu region.
Äänekoski
Bioproduct mill with recovery boiler, lime kiln and wood dust areas.
Field notes · Finland

More about Finland that matters for portable equipment

Finland: infrastructure

About 2.8 million Finns rely on district heating, so combined heat and power plants and fuel handling sites exist in nearly every town.

Finland: industry on the ground

Bioenergy and waste make up 33.6% of total energy supply and peat 2.7%, with Finland one of the last countries still burning peat, which brings fuel-dust handling into power and heat plants.

Finland: climate and equipment wear

Energy use per capita is the highest in the EU, partly because of energy-intensive industry, a cold climate and long distances, so winter operation of handheld equipment is a normal planning point.

Finland: rules and approvals

The Finnish Safety and Chemicals Agency, Tukes, monitors safety in technology, chemicals and hazardous materials, with divisions for facilities and mines and for products and equipment, and is Finland's competent authority for REACH, CLP and Seveso III.

The term · hazardous area

What “hazardous area” means for a smartphone

A hazardous area is a place where flammable gas, vapour or combustible dust may be present. Standards divide these into zones: Zones 0, 1 and 2 for gas and vapour, and Zones 20, 21 and 22 for dust. Zone 1 and Zone 21 are the tier where an explosive atmosphere is likely to occur in normal operation, which is where the IS-04Z1 is designed to work. Anything carried in must be marked for the zone, gas group and temperature class of the area.

No certificate has been issued for the IS-04Z1 yet, so it must not be taken into a classified area until the certificate covering it exists and the site operator has accepted it.

In Finland. Finnish classified areas range from the Kilpilahti refinery and cracker to kraft mill recovery boilers, lime kilns and chip piles, plus gas network sites such as the Inkoo terminal. Classification is carried out by the operator, in line with national rules, not by SAMS. The device must then be matched to each zone and dust or gas group.

The route · supply

Sourcing the IS-04Z1 for Finland

Supply of the IS-04Z1 to Finland starts only after certification, through authorised distributors. Until then a buyer can request the datasheet and the written certification schedule, and arrange a safe-area evaluation unit, which puts the site on the list for the right local channel at launch.

  1. 01

    Request the datasheet

    The technical specification, marking target and conditions of use, sent by email.

  2. 02

    Ask for the certification schedule

    Which certificates are in progress, in what order, and what is still to be confirmed.

  3. 03

    Evaluate in a safe area

    Evaluation units can be used for connectivity, MDM enrolment and workflow testing outside classified areas.

  4. 04

    Register for launch

    Tell us the site, zone, gas group and quantity so the right authorised distributor can contact you.

Questions · Finland

Frequently asked questions

Can we buy a hazardous area mobile phone in Finland today?

No. Nothing can be bought or taken into a classified area today: certification is in progress and launch is planned for Q4 2026. What is available now is the datasheet, the written certification schedule and evaluation units for safe-area use.

What does a hazardous area mobile phone in Finland cost?

There is no list price yet. SAMS gives indicative pre-launch pricing in writing, against a stated quantity and site, and does not commit to a lead time before certification completes.

Which hazardous areas is the IS-04Z1 designed for?

Zone 1 and Zone 21 (gas and dust) with gas group IIC and temperature class T4, subject to certification. It must not be used in a classified area before its certificate is issued and the site has accepted it.

Which sites in Finland does this cover?

The market guide for Finland covers Kilpilahti, Porvoo, Naantali, Kokkola, Harjavalta, among others. Site-level pages are linked below.

How will SAMS supply Finland?

Through authorised distributors once certificates exist. Until then SAMS can send the datasheet and certification schedule and arrange safe-area evaluation units.

Do Finnish biomass and peat plants have different explosion risks from refineries?

Yes, because fuel dust from wood, biomass and peat is combustible, so dust zones such as Zone 21 and Zone 22 matter alongside gas zones. Choose devices with dust group marking suitable for the site's classification drawings and the operator's own requirements.

How does Finland's cold climate affect Ex handheld devices?

Winter temperatures can fall well below the minimum rating of ordinary electronics, and battery capacity drops in the cold. Check the lowest rated ambient temperature on the certificate, glove-friendly touch operation and whether charging must happen indoors outside the classified area.

Do contractors at Kilpilahti need their own approved devices?

Gate procedures and contractor rules are set by the operator and the site authority, so requirements vary. A contractor would normally be asked for evidence that a device suits the zones it enters. Check the rules with the site before bringing any device in.

Enquiry · Finland

Ask about the IS-04Z1 for Finland

Share the site details and quantity. You will get the datasheet and the certification schedule back by email; pricing is indicative only until launch.

Enquiry · Finland

Please enter your name.
Please enter your company name.
Enter a valid email address.
Please enter your target market.
Please select one.

Launching Q4 2026

Planning for Finland?

Tell us the zone, gas group and operator. We will send the datasheet and the certification schedule.