South Africa: industry on the ground
South Africa is the world's largest producer of chrome, manganese, platinum and vanadium and the third-largest coal exporter, so mining is a major source of hazardous-area work.
A Zone 1 / Zone 21 smartphone for crews at the Secunda and Sasolburg complexes, the Natref and Cape Town refineries, Mossel Bay, the fuel terminals and the surface plants of South African mining. South Africa has a National Code of Practice for Electrical Machinery in Hazardous Locations under the Occupational Health and Safety Act 1993, with a section on regulatory requirements for explosion-protected apparatus. A rugged cell phone distributor in South Africa would carry the IS-04Z1 to these buyers once certification completes.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. South Africa has no appointed SAMS distributor yet: the IS-04Z1 is pre-launch (certification in progress, no certificate issued, launch planned for Q4 2026), and distributor applications are open.
Status: pre-launch. IECEx, ATEX, UKEX and NEC 500 certification is in progress and no certificate has been issued; launch is planned for Q4 2026. Operator approval runs on its own timeline. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Ingress protection | IP65 to IP68 sealing | IP68 design |
| Drop and shock | A stated drop height onto concrete | Specification on request |
| Explosion protection | A separate certificate and marking | In progress; not issued |
| Where it applies | South Africa: Milnerton, Cape Town, Mossel Bay, Western Cape, Durban | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in South Africa. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
The classified areas, operators and sites below are the ones covered in the SAMS South Africa market guide.
South Africa is the world's largest producer of chrome, manganese, platinum and vanadium and the third-largest coal exporter, so mining is a major source of hazardous-area work.
The code references a family of SANS standards, including SANS 10086 on installation, inspection and maintenance of equipment in explosive atmospheres, SANS 1489 on connectors and SANS 1515 on gas measuring equipment for mines.
ICASA, based in Centurion, sets radio type approval, relying on EU test reports for spectrum, EMC and electrical safety, and a conformity label must be affixed to the equipment and the packaging.
Secunda CTL, owned by Sasol, is the world's largest coal liquefaction plant, with capacity of 160,000 barrels a day from units built in 1980 and 1984, so synthetic fuel gas and liquids handling is extensive.
A rugged phone is built to survive water, dust, drops and rough handling, usually rated by an IP code and a drop specification. Ruggedness is an environmental property: it says nothing about whether a phone may be used where flammable gas or dust is present. That is decided by explosion-protection certification and marking.
The IS-04Z1 combines both: an IP68 sealed rugged build and a design for Zone 1 and Zone 21 (marking target Ex ib IIC T4). The explosion-protection certificates are in progress and none has been issued.
In South Africa. Highveld summers are hot, winter mornings are cold and storms are violent, with coal and mineral dust over everything. IP68 sealing keeps water and dust out, and the certificate will state the approved ambient range. IP68 is an ingress rating and gives no protection against explosion.
A distributor for South Africa would carry the IS-04Z1 after certification completes; the Q4 2026 launch is the planning date and no appointment has been made. SAMS reviews applicants one by one and prefers companies with their own Ex-competent technical and service staff, since certified devices must not be repaired outside approved channels.
Not yet. The IS-04Z1 is pre-launch and its certification is still in progress ahead of a Q4 2026 launch. No unit goes into a classified area before the certificate covering it exists. The datasheet, the certification schedule and safe-area evaluation units are available now.
There is no list price yet. SAMS gives indicative pre-launch pricing in writing, against a stated quantity and site, and does not commit to a lead time before certification completes.
It is designed to IP68 sealing, with glove-friendly controls. Ruggedness is not explosion protection: that depends on the certificates, which are in progress.
The market guide for South Africa covers Secunda, Mpumalanga, Sasolburg, Free State, Milnerton, Cape Town, Mossel Bay, Western Cape, among others. Site-level pages are linked below.
Apply through the distributor page with your company details and the territory you cover. SAMS reviews applications company by company and has not yet granted a territory for South Africa.
Underground mines typically use Group I classification, with methane and coal-dust risks, while surface plants use Group II and III. SANS standards such as SANS 1515 cover mine gas-measuring equipment. Ask the mine or plant engineer which group and protection level the area drawing specifies before ordering.
Yes. The National Code of Practice for Electrical Machinery in Hazardous Locations sits under the Occupational Health and Safety Act 1993 and refers to SANS standards. Mines also have their own regulations and standards, so confirm which rules apply with the site's engineering and compliance team.
No. Underground mining is equipment Group I, which is outside the scope of this device. The IS-04Z1 targets surface areas such as coal handling plants and process units using Zone 1 and Zone 21. Confirm the area and equipment group with the mine's safety officer.
More on South Africa, and on other places in South Africa.
Tell us what you need to equip and where. The SAMS team answers by email with the datasheet and where each certification route stands.
Tell us the zone, gas group and operator. We will send the datasheet and the certification schedule.