Lindsey
Lindsey closed in 2025 after owner Prax became insolvent; Phillips 66 agreed in January 2026 to acquire assets but said it will not restart it as a standalone refinery.
England hosts three of the UK's four operating refineries, Fawley, Stanlow and Humber, with Pembroke in Wales the fourth. Major-hazard sites fall under the Control of Major Accident Hazards Regulations 2015, with HSE publishing guidance and public information on establishments covered, so top-tier and lower-tier sites follow a further regime. Distribution partners for England are being identified ahead of the Q4 2026 launch of the IS-04Z1.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. England has no appointed SAMS distributor yet: the IS-04Z1 is pre-launch (certification in progress, no certificate issued, launch planned for Q4 2026), and distributor applications are open.
For the record, no certificate exists for the IS-04Z1 today. The programme is under way ahead of a Q4 2026 launch. A buyer's engineering review is separate from the certificate. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Level of protection | ia, ib or ic matched to the zone | ib, for Zone 1 |
| Entity parameters | Uo, Io and Po within the device limits | Published with the certificate |
| Accessories | Chargers and cases certified with the device | Defined at certification |
| Where it applies | England: Marine oil jetties, Petrochemical units, Refinery process units | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in England. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
The companies on site and the hazardous-area types a handset is likely to meet there.
Lindsey closed in 2025 after owner Prax became insolvent; Phillips 66 agreed in January 2026 to acquire assets but said it will not restart it as a standalone refinery.
DSEAR applies, and the UK recognises CE marking alongside UKCA for Great Britain, with the recognition period currently running to 31 December 2027.
COMAH 2015 is enforced by a joint Competent Authority: HSE, or the Office for Nuclear Regulation for nuclear sites, working with the Environment Agency in England, Natural Resources Wales or SEPA in Scotland.
Employers must identify and classify areas where explosive atmospheres may occur and avoid ignition sources, for example from unprotected equipment, in those areas.
HSE lists dangerous substances as including solvents, paints, varnishes, flammable gases such as LPG, dusts from machining, sanding and foodstuffs, pressurised gases and substances corrosive to metal.
DSEAR duties fall on employers and the self-employed and also protect members of the public who may be put at risk by work activity, so contractors share responsibility with site owners.
Intrinsic safety limits the electrical and thermal energy in a circuit so that neither a spark nor a hot surface can ignite a gas or dust atmosphere, even when a fault occurs. The ib level, used for Zone 1, tolerates one fault. It is the usual way to make a handheld device that a worker carries continuously through a hazardous area.
The IS-04Z1 is designed on this principle for Zone 1 and Zone 21 (marking target II 2 G Ex ib IIC T4). Intrinsic safety is a design basis, not a certificate: certification is in progress and none has been issued yet.
In England. Operators at Fawley on Southampton Water, Stanlow in Cheshire and the Humber site make rounds over process units, tank farms and jetties. A handheld designed for intrinsic safety suits those rounds and turnaround inspection, since photographs, readings and permits can be handled at the point of work without leaving the classified area.
A distributor for England would carry the IS-04Z1 after certification completes; the Q4 2026 launch is the planning date and no appointment has been made. SAMS reviews applicants one by one and prefers companies with their own Ex-competent technical and service staff, since certified devices must not be repaired outside approved channels.
Not today. Until the certificates are issued the IS-04Z1 stays out of classified areas, and until launch there is nothing to purchase. You can ask for the datasheet and the certification schedule, or book a safe-area evaluation unit.
No price is published. While certification is in progress there is no list price and no committed lead time, and a supplier quoting a firm figure for an uncertified Ex handset is promising something it cannot stand behind. Indicative pre-launch pricing is issued in writing against a stated quantity and site.
The circuits are designed to limit energy so a spark or hot surface cannot ignite a gas or dust atmosphere, even with one fault (level ib, Zone 1). Certification of that design is in progress.
Likely candidates are refinery process units, fuel terminals and tank farms, marine oil jetties, petrochemical units. Which areas are classified, and to what zone, is set by the site operator's own area classification drawings.
Apply through the distributor page with your company details and the territory you cover. SAMS reviews applications company by company and has not yet granted a territory for England.
COMAH applies to major-hazard sites such as large chemical and fuel storage establishments and adds management duties on top of DSEAR. Each operator typically sets its own rules for portable electronics, so check the site's permit and induction requirements.
The Dangerous Substances and Explosive Atmospheres Regulations 2002 require employers to classify hazardous areas and avoid ignition sources. Equipment choice is then based on the zone, gas group and temperature class, so ask the site for its hazardous-area register.
Guidance says CE marking is recognised alongside UKCA for Great Britain, with the recognition period currently running to 31 December 2027, and that date may change. Buyers should check the current gov.uk guidance and ask their operator's procurement team what evidence they require.
Related guides for England and for United Kingdom.
Tell us what you need to equip and where. The SAMS team answers by email with the datasheet and where each certification route stands.
Name the site and the operator and we will send what is available before launch.