United States: rules and approvals
Zone-rated equipment in the US carries the AEx marking, for example Class I, Zone 0, AEx ia IIC T6, so a datasheet showing only ATEX or IECEx marks does not show US approval.
The IS-04Z1 is built for people who work inside classified locations at American refineries, gas plants, terminals and wellsites, and for the HSE and IT teams who decide what goes through the gate. This page explains what to look for in an Ex-proof smartphone for United States, and where the IS-04Z1 stands against that list today.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for United States: pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.
For the record, no certificate exists for the IS-04Z1 today. The programme is under way ahead of a Q4 2026 launch. Operator approval runs on its own timeline. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Ex marking | Group, category, protection concept, gas group, temperature class | II 2 G Ex ib IIC T4 (target) |
| Gas group | IIA, IIB or IIC matched to the area drawing | IIC (target) |
| Temperature class | T-class below the ignition temperature of the gas | T4, 135 °C (target) |
| Where it applies | United States: Permian Basin, Houston Ship Channel, Beaumont and Port Arthur | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in United States. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
The classified areas, operators and sites below are the ones covered in the SAMS United States market guide.
Zone-rated equipment in the US carries the AEx marking, for example Class I, Zone 0, AEx ia IIC T6, so a datasheet showing only ATEX or IECEx marks does not show US approval.
US workplace rules accept electrical equipment in explosive atmospheres only if it is approved by an OSHA-recognised NRTL, and OSHA states that the NRTL's specific mark is required, so CE and ATEX do not count.
The Permian also yields potash, mined by the room-and-pillar method in Lea and Eddy counties in New Mexico, which adds mining and mineral-dust hazards to the oil and gas activity.
For Zone approval the ANSI/UL and ANSI/ISA 60079 series apply, and ordinary-location electrical safety standards such as ANSI/UL 61010 must also be met.
“Ex-proof” is shorthand for equipment carrying an explosion-protection marking (the Ex mark) that matches the area it enters. The marking states the protection concept, gas or dust group and temperature class, and it must be backed by a certificate issued by a recognised body, so a phone described as Ex-proof should come with a certificate number you can check.
The IS-04Z1 is designed to carry the marking II 2 G Ex ib IIC T4. That is a target: certification is in progress, no certificate has been issued, and SAMS will publish the certificate numbers when they exist.
In United States. A US marking check reads the ATEX target II 2 G Ex ib IIC T4 and the Class I Division 1 listing pursued on the same basis. IIC maps to NEC Groups A and B, above Group D. Combustible dust at sulfur handling, coal transfer and solids charging is read against Zone 21 and Class II.
A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.
Not today. Until the certificates are issued the IS-04Z1 stays out of classified areas, and until launch there is nothing to purchase. You can ask for the datasheet and the certification schedule, or book a safe-area evaluation unit.
No price is published. While certification is in progress there is no list price and no committed lead time, and a supplier quoting a firm figure for an uncertified Ex handset is promising something it cannot stand behind. Indicative pre-launch pricing is issued in writing against a stated quantity and site.
The marking target is II 2 G Ex ib IIC T4. It becomes a marking only when the certificate is issued; until then it is a design target.
The market guide for United States covers Permian Basin, Houston Ship Channel, Beaumont and Port Arthur, Lake Charles and Calcasieu, among others. Site-level pages are linked below.
Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.
The basin is dry and sparsely built, so summer heat, dust and long drives between sites are typical. Check the operating temperature range, dust ingress rating and battery life, and confirm any operator-specific site rules, including permits and gas detection practice, with the company controlling the lease.
Radio-containing devices such as phones normally need FCC equipment authorisation, either by certification through an approved body or a supplier's declaration depending on the device type. Check the FCC rules and consult an accredited test lab or telecommunication certification body for your product's category.
The Zone 21 design target covers dust at sulfur handling, coal transfer and solids charging, but certification is in progress and no listing exists. Check which Class and Division the final listing covers against your facility's own classification before use.
More on United States, and on other places in United States.
Share the site details and quantity. You will get the datasheet and the certification schedule back by email; pricing is indicative only until launch.
Send the zone and gas group of your site and we will reply with the datasheet and schedule.