Australia: people and language
The Pilbara has more than 45,000 residents, most living in the western third in towns such as Port Hedland, Karratha and Wickham, while the eastern third is almost entirely desert.
A Zone 1 / Zone 21 smartphone for crews on Australian LNG trains, offshore facilities, processing plants and remote mine sites. This page explains what to look for in an ATEX and IECEx smartphone for Australia, and where the IS-04Z1 stands against that list today.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for Australia: pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.
For the record, no certificate exists for the IS-04Z1 today. The programme is under way ahead of a Q4 2026 launch. A buyer's engineering review is separate from the certificate. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Marking | II 2 G Ex ib IIC T4 on the rating plate | Design target; not yet marked |
| EU-type examination certificate | Notified body number and certificate ID | In progress with TÜV; not issued |
| IECEx certificate of conformity | Number listed on the IECEx online register | In progress; not issued |
| Where it applies | Australia: Karratha and the Burrup Peninsula, Onslow, Western Australia, Darwin | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Australia. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
Operators and classified areas drawn from the SAMS Australia market guide.
The Pilbara has more than 45,000 residents, most living in the western third in towns such as Port Hedland, Karratha and Wickham, while the eastern third is almost entirely desert.
The Pilbara covers 507,896 square kilometres in the north of Western Australia, a large, dry, sparsely populated region known for iron ore, with four local government areas.
ANZEx has been owned by JAS-ANZ since August 2016, and Queensland's Electrical Safety Regulation 2026 took effect on 1 September 2026, so state rules continue to evolve.
Operators typically check for a current IECEx or ANZEx certificate, a suitable gas group and temperature class, a Hazardous Area Verification Dossier under AS/NZS 60079.14 and installer competency.
ATEX is the European legal framework for equipment used in explosive atmospheres (Directive 2014/34/EU). IECEx is the international certification scheme built on the IEC 60079 standards. Buyers outside Europe often ask for both: an IECEx certificate is the technical evidence most national regimes build on, while ATEX is the legal route into the European market.
For the IS-04Z1 both routes are in progress with TÜV in Germany and neither certificate has been issued. The marking target is II 2 G Ex ib IIC T4: equipment Group II (surface industry), Category 2 (Zone 1 gas), protection concept ib (intrinsic safety), gas group IIC and temperature class T4.
In Australia. Australian sites work from an IECEx Certificate of Conformity, so an HSE or electrical reviewer would ask for that first, and ANZEx issues a national certificate from the same test reports. An ATEX certificate alongside it helps international EPCs and contractors, such as Worley or Clough, who move between Australian LNG projects and overseas assets. All of these are in progress.
A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.
Not yet. The IS-04Z1 is pre-launch and its certification is still in progress ahead of a Q4 2026 launch. No unit goes into a classified area before the certificate covering it exists. The datasheet, the certification schedule and safe-area evaluation units are available now.
SAMS has not published a price. Any figure you are offered for an uncertified Ex phone should be treated with caution; written indicative pricing is available for a defined quantity and site.
Not yet. Both routes are in progress with TÜV in Germany and no certificate has been issued. Any listing that says otherwise is wrong.
The market guide for Australia covers Karratha and the Burrup Peninsula, Onslow, Western Australia, Darwin, Gladstone and Curtis Island, among others. Site-level pages are linked below.
Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.
The Pilbara is hot, dry and dusty, with long distances between sites and towns. Check the operating temperature range, dust ingress rating and battery life in heat, and confirm with the operator any site rules on permits, inductions and mobile devices in classified areas.
It is the installation documentation expected under AS/NZS 60079.14, showing that the equipment, its certificate and its installation suit the classified area. Operators and inspectors look for it before energising equipment, so ask the site electrical team what must be supplied with portable and fixed equipment.
The target marking is T4 with the ambient range to be fixed on the certificate, which is not yet issued. The 4,000 mAh battery is sized for a roster day with radio, camera and GNSS running. Check the certified range against your site's worst summer ambient and trial a unit before fleet orders.
Other guides for Australia, other places in Australia, and the pages behind them.
Share the site details and quantity. You will get the datasheet and the certification schedule back by email; pricing is indicative only until launch.
Send the zone and gas group of your site and we will reply with the datasheet and schedule.