Remote northern sites
Large operations lie to the north of Fort McMurray; Canadian Natural's Horizon leases, for example, are about 70 km north of the city, so crews depend on site-wide communications and shuttle logistics.
The Athabasca oil sands of northern Alberta are worked by open-pit mines with on-site upgraders and by in situ SAGD projects, all centred on Fort McMurray. Bitumen extraction, upgrading and diluent handling create hydrocarbon areas where Zone 1 and Zone 2 equipment is specified. If you are specifying an ATEX and IECEx mobile phone for Alberta oil sands (Athabasca), this page covers the markings, the approvals and the current certification status of the IS-04Z1.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for Alberta oil sands (Athabasca): pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.
Where things stand: the IS-04Z1 has not launched, and none of its four certification routes has produced a certificate yet. Operator approval runs on its own timeline. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Marking | II 2 G Ex ib IIC T4 on the rating plate | Design target; not yet marked |
| EU-type examination certificate | Notified body number and certificate ID | In progress with TÜV; not issued |
| IECEx certificate of conformity | Number listed on the IECEx online register | In progress; not issued |
| Where it applies | Alberta oil sands (Athabasca): Bitumen extraction and froth treatment, Upgrader process units, Diluent and naphtha handling | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Alberta Oil Sands. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
The companies on site and the hazardous-area types a handset is likely to meet there.
Large operations lie to the north of Fort McMurray; Canadian Natural's Horizon leases, for example, are about 70 km north of the city, so crews depend on site-wide communications and shuttle logistics.
Fort McMurray has a borderline subarctic climate with January averages around -17 degrees C and extreme lows below -50 degrees C, which affects battery performance and handset ratings.
Of the oil underlying about 142,200 km2, only about 4,800 km2 may potentially be surface mined, so most future volumes come from in-situ drilling and steam injection rather than mining.
Operators in the Athabasca region have included Syncrude, Suncor, Canadian Natural Resources, TotalEnergies, Imperial Oil, Petro-Canada, Devon, Husky, Statoil and Nexen, with ownership changing over time.
Athabasca oil sands are typically 40 to 60 m thick and sit under 1 to 3 m of waterlogged muskeg and up to 75 m of clay and sand, which is why the world's first oil sands mine was opened there.
Commercial production began in 1967 with the Great Canadian Oil Sands plant at Fort McMurray, a 240 million US dollar project with a capacity of 45,000 barrels a day.
ATEX is the European legal framework for equipment used in explosive atmospheres (Directive 2014/34/EU). IECEx is the international certification scheme built on the IEC 60079 standards. Buyers outside Europe often ask for both: an IECEx certificate is the technical evidence most national regimes build on, while ATEX is the legal route into the European market.
For the IS-04Z1 both routes are in progress with TÜV in Germany and neither certificate has been issued. The marking target is II 2 G Ex ib IIC T4: equipment Group II (surface industry), Category 2 (Zone 1 gas), protection concept ib (intrinsic safety), gas group IIC and temperature class T4.
In Alberta oil sands (Athabasca). A reviewer at an Athabasca oil sands operator would expect certificate evidence tied to hydrocarbon areas around extraction, upgrading and diluent handling. A dual ATEX and IECEx route, once issued, would help contractors who move between operators such as Suncor, Imperial Oil or Cenovus. The IS-04Z1 is still in certification, so nothing is held today.
A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.
Not yet. The IS-04Z1 is pre-launch and its certification is still in progress ahead of a Q4 2026 launch. No unit goes into a classified area before the certificate covering it exists. The datasheet, the certification schedule and safe-area evaluation units are available now.
No price is published. While certification is in progress there is no list price and no committed lead time, and a supplier quoting a firm figure for an uncertified Ex handset is promising something it cannot stand behind. Indicative pre-launch pricing is issued in writing against a stated quantity and site.
Not yet. Both routes are in progress with TÜV in Germany and no certificate has been issued. Any listing that says otherwise is wrong.
Likely candidates are bitumen extraction and froth treatment, upgrader process units, diluent and naphtha handling, sagd well pads and central processing facilities. Which areas are classified, and to what zone, is set by the site operator's own area classification drawings.
Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.
Yes, typically. SAGD pads and central plants handle steam, hot bitumen, produced gas and diluent, so classified areas are more common than in a mine pit. Confirm the zone map and gas groups with the operator, and use certified devices accordingly.
Winters are severe in northern Alberta, so batteries lose capacity and screens, seals and cables stiffen. Choose devices rated for low temperatures and confirm the operator's winter equipment guidelines and temperature class for classified areas.
Yes, in practice. Fort McMurray averages about -17 degrees C in January and has seen lows below -50 degrees C, so battery performance and touchscreen use with gloves need checking against the datasheet. Many crews use sheltered charging points. Confirm the permitted temperature range with the site operator before relying on any device outdoors.
More on Alberta Oil Sands, and on other places in Canada.
Send the site, zone and gas group and roughly how many handsets. We reply by email with the datasheet and the certification schedule.
Tell us the zone, gas group and operator. We will send the datasheet and the certification schedule.