Czech Republic: infrastructure
The Gazela pipeline connects Czech gas supply through Germany at Brandov or Rozvadov and through Slovakia at Lanžhot, so compressor and metering stations sit near the borders.
The IS-04Z1 is an intrinsically safe Android handset designed for Zone 1 and Zone 21, built for Czech refineries, chemical plants, tank farms and coke ovens rather than for a catalogue. If you are specifying an intrinsically safe smartphone for Czech Republic, this page covers the markings, the approvals and the current certification status of the IS-04Z1.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for Czech Republic: pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.
Where things stand: the IS-04Z1 has not launched, and none of its four certification routes has produced a certificate yet. Operator approval runs on its own timeline. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Level of protection | ia, ib or ic matched to the zone | ib, for Zone 1 |
| Entity parameters | Uo, Io and Po within the device limits | Published with the certificate |
| Accessories | Chargers and cases certified with the device | Defined at certification |
| Where it applies | Czech Republic: Litvínov and Záluží, Kralupy nad Vltavou, Neratovice | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Czech Republic. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
The classified areas, operators and sites below are the ones covered in the SAMS Czech Republic market guide.
The Gazela pipeline connects Czech gas supply through Germany at Brandov or Rozvadov and through Slovakia at Lanžhot, so compressor and metering stations sit near the borders.
In 2022 electricity production was 78.8 TWh, of which 53.6% came from fossil fuels, mostly lignite, and 40.95% from nuclear, so coal-handling plants and power stations are typical dust and gas sites.
ATEX equipment is split into Group I for mining and Group II for surface industries, which matters in a country with coal mining as well as refining and chemicals.
Gas use was 9.4 billion cubic metres in 2021 and 7.1 billion in 2023, so gas distribution and industrial gas burners remain widespread across Czech industry.
Intrinsic safety limits the electrical and thermal energy in a circuit so that neither a spark nor a hot surface can ignite a gas or dust atmosphere, even when a fault occurs. The ib level, used for Zone 1, tolerates one fault. It is the usual way to make a handheld device that a worker carries continuously through a hazardous area.
The IS-04Z1 is designed on this principle for Zone 1 and Zone 21 (marking target II 2 G Ex ib IIC T4). Intrinsic safety is a design basis, not a certificate: certification is in progress and none has been issued yet.
In Czech Republic. Rounds at Záluží, Nelahozeves or Ostrava involve walking long distances across extended plants in cold weather, with no charger inside a classified area. An intrinsically safe handheld is designed for those rounds, with a 4,000 mAh battery sized for a whole shift with the camera and a maintenance application in use.
A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.
Not yet. The IS-04Z1 is pre-launch and its certification is still in progress ahead of a Q4 2026 launch. No unit goes into a classified area before the certificate covering it exists. The datasheet, the certification schedule and safe-area evaluation units are available now.
SAMS has not published a price. Any figure you are offered for an uncertified Ex phone should be treated with caution; written indicative pricing is available for a defined quantity and site.
The circuits are designed to limit energy so a spark or hot surface cannot ignite a gas or dust atmosphere, even with one fault (level ib, Zone 1). Certification of that design is in progress.
The market guide for Czech Republic covers Litvínov and Záluží, Kralupy nad Vltavou, Neratovice, Valašské Meziříčí, among others. Site-level pages are linked below.
Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.
Yes. ATEX separates Group I equipment for mining from Group II for surface industries, and methane and coal dust conditions underground differ from refinery gas and vapour. Check the Group marking on any device against the area and the mine operator's own approval process.
Crude arrives by pipeline from Germany and Italy, with storage at depots such as Nelahozeves, so many classified areas are at pumping and storage sites rather than ports. Terminal operators run their own induction and device registration, so schedule approvals early for shutdown work.
Czech law expects the instructions in Czech, so the manual, safe-use guidance and declaration of conformity are planned in Czech alongside English, with a Czech interface on Android 16. That is planned into the launch rather than translated afterwards. Certification is in progress. Check requirements with your safety officer.
Related guides for Czech Republic and for Czech Republic.
Share the site details and quantity. You will get the datasheet and the certification schedule back by email; pricing is indicative only until launch.
Name the site and the operator and we will send what is available before launch.