Skip to content
Certification In Progress · Launching Q4 2026 Become a Distributor
Certification In Progress · Launching Q4 2026 Product Certifications Industries Blog About Contact Become a Distributor
Poland · intrinsically safe

Intrinsically Safe Cell Phone Supplier in Poland

The IS-04Z1 is an intrinsically safe Android handset designed for Zone 1 and Zone 21, built for the refinery, fertiliser and gas terminal work where Polish teams actually meet an explosive atmosphere. Buyers searching for an intrinsically safe cell phone supplier for Poland can take the datasheet and the certification schedule for the IS-04Z1 now; supply follows certification.

Pre-launch · certification in progress · Launching Q4 2026

SAMS IS-04Z1 intrinsically safe smartphone for Poland, front view
Marking targetEx ib IIC T4Intrinsic safety, Zone 1 / 21 design target · certification in progress
AvailabilityQ4 2026via authorised distributors
Search topicintrinsically safe
DeviceCell Phone
RouteSupply
WherePoland

Short answer. An intrinsically safe cell phone for Poland cannot be bought yet: the SAMS IS-04Z1 is pre-launch (certification in progress, no certificate issued), and the datasheet, certification schedule and safe-area evaluation units are available now.

Current position: certification in progress, nothing issued, launch targeted for Q4 2026. An operator's own vendor approval is a separate step. Certification status. Place facts reviewed October 2026.

At a glance · intrinsically safe

Checklist: intrinsically safe cell phone for Poland

What to check, and where the IS-04Z1 stands today
CheckWhat to look forIS-04Z1 today
Level of protectionia, ib or ic matched to the zoneib, for Zone 1
Entity parametersUo, Io and Po within the device limitsPublished with the certificate
AccessoriesChargers and cases certified with the deviceDefined at certification
Where it appliesPoland: Police, Tarnów, PłockClassified by the site operator
Product · Poland

The product behind this search: the SAMS IS-04Z1.

SAMS IS-04Z1 explosion proof mobile phone, front view

SAMS IS-04Z1

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Poland. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.

  • IP68 sealed
  • 4,000 mAh battery
  • 50 MP camera
  • Android 16
  • Zone 1 / Zone 21 design target
The market · Poland

Where this applies in Poland

The classified areas, operators and sites below are the ones covered in the SAMS Poland market guide.

Operators, EPCs and contractors

Orlen
Płock and Gdańsk refineries and the Płock petrochemical complex.
Orlen Południe
Biorefining and base oil plants at Trzebinia and Jedlicze.
Anwil
PVC, caustic soda and nitrogen fertilisers at Włocławek.
Grupa Azoty
Nitrogen and chemical plants at Tarnów, Puławy and Police.
Grupa Azoty Polyolefins
The Polimery Police propylene and polypropylene complex.
Gaz-System
Transmission grid, Baltic Pipe and the Świnoujście LNG terminal.

Industrial areas and sites

Płock
The largest refining and petrochemical complex in the country.
Gdańsk
Coastal refinery, oil terminal and pipeline tank farms.
Włocławek
Chlorine, PVC and fertiliser plants on the Vistula.
Puławy
Nitrogen fertiliser and melamine production in Lublin province.
Police
Fertiliser complex and the new polypropylene units on the Oder.
Tarnów
The original Azoty nitrogen and plastics site in Małopolska.
Field notes · Poland

More about Poland that matters for portable equipment

Poland: background

Poland produced 78 megatonnes of hard coal and 57 megatonnes of brown coal in 2009, and a plan agreed in September 2020 aims to phase out coal by 2049.

Poland: industry on the ground

Poland's energy sector is the fifth largest in Europe, with an installed electricity capacity of about 61 GW at the end of 2024, so power plants and mines are large sources of classified areas.

Poland: industry on the ground

In 2020 coal made up 69.5% of national energy production and 68.5% of electricity generation, so coal handling, bunkers and mills create combustible dust zones at many power sites.

Poland: background

PKN Orlen was created in 1999 by merging the state fuel retailer CPN with Petrochemia Płock, the firm running the Płock refineries, and has since grown into a multinational refiner and gas trader.

The term · intrinsically safe

What “intrinsically safe” means for a smartphone

Intrinsic safety limits the electrical and thermal energy in a circuit so that neither a spark nor a hot surface can ignite a gas or dust atmosphere, even when a fault occurs. The ib level, used for Zone 1, tolerates one fault. It is the usual way to make a handheld device that a worker carries continuously through a hazardous area.

The IS-04Z1 is designed on this principle for Zone 1 and Zone 21 (marking target II 2 G Ex ib IIC T4). Intrinsic safety is a design basis, not a certificate: certification is in progress and none has been issued yet.

In Poland. A cold, wet outdoor round at Płock, Gdańsk or Police is a long shift with no safe-area charging. An intrinsically safe handheld lets an operator log findings, photograph equipment and open a work-order app without leaving the zone. It suits turnaround work at Puławy and Kędzierzyn-Koźle as well.

The route · supply

Sourcing the IS-04Z1 for Poland

Supply of the IS-04Z1 to Poland starts only after certification, through authorised distributors. Until then a buyer can request the datasheet and the written certification schedule, and arrange a safe-area evaluation unit, which puts the site on the list for the right local channel at launch.

  1. 01

    Request the datasheet

    The technical specification, marking target and conditions of use, sent by email.

  2. 02

    Ask for the certification schedule

    Which certificates are in progress, in what order, and what is still to be confirmed.

  3. 03

    Evaluate in a safe area

    Evaluation units can be used for connectivity, MDM enrolment and workflow testing outside classified areas.

  4. 04

    Register for launch

    Tell us the site, zone, gas group and quantity so the right authorised distributor can contact you.

Questions · Poland

Frequently asked questions

Can we buy an intrinsically safe cell phone in Poland today?

Not yet. The IS-04Z1 is pre-launch and its certification is still in progress ahead of a Q4 2026 launch. No unit goes into a classified area before the certificate covering it exists. The datasheet, the certification schedule and safe-area evaluation units are available now.

What does an intrinsically safe cell phone in Poland cost?

SAMS has not published a price. Any figure you are offered for an uncertified Ex phone should be treated with caution; written indicative pricing is available for a defined quantity and site.

What does ‘intrinsically safe’ mean for the IS-04Z1?

The circuits are designed to limit energy so a spark or hot surface cannot ignite a gas or dust atmosphere, even with one fault (level ib, Zone 1). Certification of that design is in progress.

Which sites in Poland does this cover?

The market guide for Poland covers Płock, Gdańsk, Włocławek, Puławy, among others. Site-level pages are linked below.

How will SAMS supply Poland?

Through authorised distributors once certificates exist. Until then SAMS can send the datasheet and certification schedule and arrange safe-area evaluation units.

Where does Poland's combustible dust risk concentrate?

Coal-fired power stations, including large brown coal plants such as Bełchatów, along with coal-using industry, handle bulk fuel that creates dust zones such as Zone 21 and Zone 22. Check that a device's dust group and temperature class match the site classification drawings.

Do Polish coal mines need different equipment from power plants?

ATEX separates Group I equipment for mining from Group II for surface industries, and underground methane and coal dust conditions differ from surface plant. Check the group marking on any device against the area and the mine operator's own approval procedure.

Can the IS-04Z1 be used in Polish coal mines?

No. It is designed as Group II surface equipment, and underground coal mining is Group I, with a separate certificate for methane and coal dust. Do not take a Group II device underground. Refineries, fertiliser plants and gas terminals are the intended areas, subject to the site operator's classification.

Enquiry · Poland

Ask about the IS-04Z1 for Poland

Share the site details and quantity. You will get the datasheet and the certification schedule back by email; pricing is indicative only until launch.

Enquiry · Poland

Please enter your name.
Please enter your company name.
Enter a valid email address.
Please enter your target market.
Please select one.

Launching Q4 2026

Planning for Poland?

Name the site and the operator and we will send what is available before launch.