United States: rules and approvals
The FCC regulates radio frequency devices between 9 kHz and 3000 GHz, and most radio-containing products must follow an equipment authorisation procedure before being marketed.
The IS-04Z1 is built for people who work inside classified locations at American refineries, gas plants, terminals and wellsites, and for the HSE and IT teams who decide what goes through the gate. This page sets out how an Ex-proof smartphone supply route to United States will work for the IS-04Z1, and what is and is not available before launch.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. An Ex-proof smartphone for United States cannot be bought yet: the SAMS IS-04Z1 is pre-launch (certification in progress, no certificate issued), and the datasheet, certification schedule and safe-area evaluation units are available now.
Status: pre-launch. IECEx, ATEX, UKEX and NEC 500 certification is in progress and no certificate has been issued; launch is planned for Q4 2026. A buyer's engineering review is separate from the certificate. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Ex marking | Group, category, protection concept, gas group, temperature class | II 2 G Ex ib IIC T4 (target) |
| Gas group | IIA, IIB or IIC matched to the area drawing | IIC (target) |
| Temperature class | T-class below the ignition temperature of the gas | T4, 135 °C (target) |
| Where it applies | United States: Baton Rouge corridor, Corpus Christi, Permian Basin | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in United States. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
Operators and classified areas drawn from the SAMS United States market guide.
The FCC regulates radio frequency devices between 9 kHz and 3000 GHz, and most radio-containing products must follow an equipment authorisation procedure before being marketed.
Zone-rated equipment in the US carries the AEx marking, for example Class I, Zone 0, AEx ia IIC T6, so a datasheet showing only ATEX or IECEx marks does not show US approval.
US workplace rules accept electrical equipment in explosive atmospheres only if it is approved by an OSHA-recognised NRTL, and OSHA states that the NRTL's specific mark is required, so CE and ATEX do not count.
The Permian also yields potash, mined by the room-and-pillar method in Lea and Eddy counties in New Mexico, which adds mining and mineral-dust hazards to the oil and gas activity.
“Ex-proof” is shorthand for equipment carrying an explosion-protection marking (the Ex mark) that matches the area it enters. The marking states the protection concept, gas or dust group and temperature class, and it must be backed by a certificate issued by a recognised body, so a phone described as Ex-proof should come with a certificate number you can check.
The IS-04Z1 is designed to carry the marking II 2 G Ex ib IIC T4. That is a target: certification is in progress, no certificate has been issued, and SAMS will publish the certificate numbers when they exist.
In United States. A US marking check reads the ATEX target II 2 G Ex ib IIC T4 and the Class I Division 1 listing pursued on the same basis. IIC maps to NEC Groups A and B, above Group D. Combustible dust at sulfur handling, coal transfer and solids charging is read against Zone 21 and Class II.
There is no stock to order for United States yet. The IS-04Z1 is pre-launch, certification is in progress, and supply will run through authorised distributors after the certificates are issued. Procurement teams can prepare now with the datasheet, the certification schedule and a safe-area evaluation.
The technical specification, marking target and conditions of use, sent by email.
Which certificates are in progress, in what order, and what is still to be confirmed.
Evaluation units can be used for connectivity, MDM enrolment and workflow testing outside classified areas.
Tell us the site, zone, gas group and quantity so the right authorised distributor can contact you.
Not yet. The IS-04Z1 is pre-launch and its certification is still in progress ahead of a Q4 2026 launch. No unit goes into a classified area before the certificate covering it exists. The datasheet, the certification schedule and safe-area evaluation units are available now.
There is no list price yet. SAMS gives indicative pre-launch pricing in writing, against a stated quantity and site, and does not commit to a lead time before certification completes.
The marking target is II 2 G Ex ib IIC T4. It becomes a marking only when the certificate is issued; until then it is a design target.
The market guide for United States covers Permian Basin, Houston Ship Channel, Beaumont and Port Arthur, Lake Charles and Calcasieu, among others. Site-level pages are linked below.
Through authorised distributors once certificates exist. Until then SAMS can send the datasheet and certification schedule and arrange safe-area evaluation units.
The basin is dry and sparsely built, so summer heat, dust and long drives between sites are typical. Check the operating temperature range, dust ingress rating and battery life, and confirm any operator-specific site rules, including permits and gas detection practice, with the company controlling the lease.
Radio-containing devices such as phones normally need FCC equipment authorisation, either by certification through an approved body or a supplier's declaration depending on the device type. Check the FCC rules and consult an accredited test lab or telecommunication certification body for your product's category.
The Zone 21 design target covers dust at sulfur handling, coal transfer and solids charging, but certification is in progress and no listing exists. Check which Class and Division the final listing covers against your facility's own classification before use.
More on United States, and on other places in United States.
Share the site details and quantity. You will get the datasheet and the certification schedule back by email; pricing is indicative only until launch.
Send the zone and gas group of your site and we will reply with the datasheet and schedule.