Switzerland: projects and investment
The Mantelerlass, passed on 29 September 2023, sets a target of 35 TWh a year from new renewable technologies by 2035, compared with about 6 TWh a year in 2022, which implies major construction work.
The IS-04Z1 is an intrinsically safe Android handset designed for solvent and powder atmospheres, from a production building in Basel or Visp to a loading rack at Cressier and a digester hall at a cantonal wastewater works. If you are specifying an Ex-proof smartphone for Switzerland, this page covers the markings, the approvals and the current certification status of the IS-04Z1.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. The SAMS IS-04Z1 is the intrinsically safe smartphone covered here for Switzerland: pre-launch, designed for Zone 1 and Zone 21 (marking target Ex ib IIC T4), with certification in progress and no certificate issued.
For the record, no certificate exists for the IS-04Z1 today. The programme is under way ahead of a Q4 2026 launch. A buyer's engineering review is separate from the certificate. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Ex marking | Group, category, protection concept, gas group, temperature class | II 2 G Ex ib IIC T4 (target) |
| Gas group | IIA, IIB or IIC matched to the area drawing | IIC (target) |
| Temperature class | T-class below the ignition temperature of the gas | T4, 135 °C (target) |
| Where it applies | Switzerland: Basel and Schweizerhalle, Visp, Monthey | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Switzerland. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
Operators and classified areas drawn from the SAMS Switzerland market guide.
The Mantelerlass, passed on 29 September 2023, sets a target of 35 TWh a year from new renewable technologies by 2035, compared with about 6 TWh a year in 2022, which implies major construction work.
Hydraulic power was used instead of steam in Swiss industry because of the mountainous terrain and lack of coal, which explains the concentration of hydro stations and tunnels in the Alps.
Switzerland produces no fossil fuels and imports petroleum, so refining and bulk fuel handling is limited, while storage depots and distribution terminals are the main flammable-liquid sites.
The three Rhine ports around Basel handle about six million tonnes and over 120,000 containers a year, roughly 10% of Swiss imports and a third of the country's mineral oil products.
“Ex-proof” is shorthand for equipment carrying an explosion-protection marking (the Ex mark) that matches the area it enters. The marking states the protection concept, gas or dust group and temperature class, and it must be backed by a certificate issued by a recognised body, so a phone described as Ex-proof should come with a certificate number you can check.
The IS-04Z1 is designed to carry the marking II 2 G Ex ib IIC T4. That is a target: certification is in progress, no certificate has been issued, and SAMS will publish the certificate numbers when they exist.
In Switzerland. A Swiss marking check reads II 2 G Ex ib IIC T4 against solvent charging points, dryers and centrifuge areas, which are the dominant Zone 1 case. Group IIC and T4 are what such areas are normally specified against. Dust in active ingredient handling puts Zone 21 metres from a gas zone.
A short checklist for anyone writing or reviewing the specification, with the IS-04Z1 status against each point.
Not yet. The IS-04Z1 is pre-launch and its certification is still in progress ahead of a Q4 2026 launch. No unit goes into a classified area before the certificate covering it exists. The datasheet, the certification schedule and safe-area evaluation units are available now.
SAMS has not published a price. Any figure you are offered for an uncertified Ex phone should be treated with caution; written indicative pricing is available for a defined quantity and site.
The marking target is II 2 G Ex ib IIC T4. It becomes a marking only when the certificate is issued; until then it is a design target.
The market guide for Switzerland covers Basel and Schweizerhalle, Visp, Monthey, Kaisten and the Fricktal, among others. Site-level pages are linked below.
Not exactly. Explosion proof is a broad everyday term; intrinsic safety is one protection concept, which limits energy so ignition cannot occur. Flameproof (Ex d) is a different concept that contains an explosion. The IS-04Z1 is intrinsically safe by design.
Switzerland is not an EU member, but it generally aligns its equipment rules with European requirements, so ATEX-marked devices are commonly accepted. Confirm the current requirement and any Swiss conformity marking with the site operator or your importer before ordering.
German, French and Italian are all national languages depending on the canton, and many industrial sites also work in English. Ask the operator which language it requires for instructions and certificates, and provide the declaration of conformity together with the Ex marking details.
IP68 sealing and a rugged build are aimed at a cleaned plant rather than a rained-on one, but your cleaning agents and routine must be checked. Test a unit with your own procedure and confirm compatibility with the site's validation team.
More on Switzerland, and on other places in Switzerland.
Share the site details and quantity. You will get the datasheet and the certification schedule back by email; pricing is indicative only until launch.
Tell us the zone, gas group and operator. We will send the datasheet and the certification schedule.