Denmark: logistics and access
Port Esbjerg calls itself the world's largest base port for offshore wind activities and says it has been involved in shipping components to more than 65 offshore wind projects.
The IS-04Z1 is an explosion proof mobile phone designed for Zone 1 and Zone 21, from a wet deck 225 km west of Esbjerg to a fermentation building at Kalundborg and a biogas upgrading skid on Lolland. Manufacturers who apply the ATEX provisions and affix CE and Ex markings may sell equipment anywhere in the EU without further requirements for those risks, so Danish buyers can use EU-wide certificates. Distribution partners for Denmark are being identified ahead of the Q4 2026 launch of the IS-04Z1.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. Denmark has no appointed SAMS distributor yet: the IS-04Z1 is pre-launch (certification in progress, no certificate issued, launch planned for Q4 2026), and distributor applications are open.
For the record, no certificate exists for the IS-04Z1 today. The programme is under way ahead of a Q4 2026 launch. An operator's own vendor approval is a separate step. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Ex marking | Group, category, protection concept, gas group, temperature class | II 2 G Ex ib IIC T4 (target) |
| Gas group | IIA, IIB or IIC matched to the area drawing | IIC (target) |
| Temperature class | T-class below the ignition temperature of the gas | T4, 135 °C (target) |
| Where it applies | Denmark: Fredericia, Kalundborg, Stigsnæs | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Denmark. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
The main operators, industrial areas and sites that the SAMS Denmark market guide covers.
Port Esbjerg calls itself the world's largest base port for offshore wind activities and says it has been involved in shipping components to more than 65 offshore wind projects.
Denmark imports about 12% of its energy but is also an exporter, and its electricity grid is connected by transmission lines to other European countries.
Denmark has North Sea oil and gas but ranked only 57th among net crude exporters in 2023 after ranking 32nd in 2008, so offshore work is mature, with decommissioning and maintenance a larger share.
North Sea natural gas projects began in 1984 and North Sea production made Denmark self-sufficient in energy in 1997, which explains the established offshore supply chain on the west coast.
“Ex-proof” is shorthand for equipment carrying an explosion-protection marking (the Ex mark) that matches the area it enters. The marking states the protection concept, gas or dust group and temperature class, and it must be backed by a certificate issued by a recognised body, so a phone described as Ex-proof should come with a certificate number you can check.
The IS-04Z1 is designed to carry the marking II 2 G Ex ib IIC T4. That is a target: certification is in progress, no certificate has been issued, and SAMS will publish the certificate numbers when they exist.
In Denmark. A marking check in Denmark would read the dust marking and maximum surface temperature as well as the gas marking, since enzyme powder, feed, grain and cement dust sit in Zone 21 and Zone 22 areas that look like ordinary buildings. The gas target is II 2 G Ex ib IIC T4, with Zone 21 under the same programme.
Distribution of the IS-04Z1 is by authorised partners only, and SAMS has not yet granted a territory for Denmark. Each application is reviewed on its merits. Because opening a certified Ex handset in an ordinary workshop invalidates its certificate, the partner must be able to support and service the device locally.
Not today. Until the certificates are issued the IS-04Z1 stays out of classified areas, and until launch there is nothing to purchase. You can ask for the datasheet and the certification schedule, or book a safe-area evaluation unit.
No price is published. While certification is in progress there is no list price and no committed lead time, and a supplier quoting a firm figure for an uncertified Ex handset is promising something it cannot stand behind. Indicative pre-launch pricing is issued in writing against a stated quantity and site.
The marking target is II 2 G Ex ib IIC T4. It becomes a marking only when the certificate is issued; until then it is a design target.
The market guide for Denmark covers Esbjerg, The Danish North Sea, Fredericia, Kalundborg, among others. Site-level pages are linked below.
Apply through the distributor page with your company details and the territory you cover. SAMS reviews applications company by company and has not yet granted a territory for Denmark.
Cold, wet and windy conditions affect battery life and touchscreen use with gloves, particularly offshore and at wind farms. Check the lowest rated ambient temperature on the certificate, the water ingress rating and whether touch input works with wet or gloved hands.
Typically the EU declaration of conformity, the certificate, the Ex marking details and instructions in the local language, which may be Danish or English depending on the operator. Request the site's equipment register template so supplier documents can be matched to it.
The classification of areas into zones comes from the emergency management agency under an executive order, while the employer's duty to assess explosion risk and hold an explosion protection document comes from the Danish Working Environment Authority. SAMS classifies nothing. Confirm the arrangement with the site operator for your plant.
More on Denmark, and on other places in Denmark.
Send the site, zone and gas group and roughly how many handsets. We reply by email with the datasheet and the certification schedule.
Tell us the zone, gas group and operator. We will send the datasheet and the certification schedule.