Italy: geography and layout
The Val d'Agri area in Basilicata hosts the largest onshore hydrocarbon field in Europe, so upstream work extends to the south of the country as well as offshore.
The IS-04Z1 is an intrinsically safe Android handset designed for Zone 1 and Zone 21, built for the refineries, petrochemical poles and gas terminals from Porto Marghera to Priolo and Sarroch. Buyers searching for an intrinsically safe cell phone supplier for Italy can take the datasheet and the certification schedule for the IS-04Z1 now; supply follows certification.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. An intrinsically safe cell phone for Italy cannot be bought yet: the SAMS IS-04Z1 is pre-launch (certification in progress, no certificate issued), and the datasheet, certification schedule and safe-area evaluation units are available now.
Where things stand: the IS-04Z1 has not launched, and none of its four certification routes has produced a certificate yet. Operator approval runs on its own timeline. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Level of protection | ia, ib or ic matched to the zone | ib, for Zone 1 |
| Entity parameters | Uo, Io and Po within the device limits | Published with the certificate |
| Accessories | Chargers and cases certified with the device | Defined at certification |
| Where it applies | Italy: Taranto, Brindisi, Priolo, Melilli and Augusta | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in Italy. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
The classified areas, operators and sites below are the ones covered in the SAMS Italy market guide.
The Val d'Agri area in Basilicata hosts the largest onshore hydrocarbon field in Europe, so upstream work extends to the south of the country as well as offshore.
Moderate natural gas reserves have been found mainly in the Po Valley and offshore in the Adriatic Sea, which concentrates gas production and processing in the north and east.
Hydropower was practically the only source of electricity until 1960, and all of Italy's active geothermal plants are in Tuscany, so dam and geothermal sites sit alongside oil and gas facilities.
Eni, which operates in 79 countries, is counted among the world's seven oil and gas supermajors, so Italian refineries and gas sites often follow large-operator procedures for contractors and equipment.
Intrinsic safety limits the electrical and thermal energy in a circuit so that neither a spark nor a hot surface can ignite a gas or dust atmosphere, even when a fault occurs. The ib level, used for Zone 1, tolerates one fault. It is the usual way to make a handheld device that a worker carries continuously through a hazardous area.
The IS-04Z1 is designed on this principle for Zone 1 and Zone 21 (marking target II 2 G Ex ib IIC T4). Intrinsic safety is a design basis, not a certificate: certification is in progress and none has been issued yet.
In Italy. A fermata at an Italian refinery or petrochemical pole brings large contractor crews through many zones in a short window. An intrinsically safe handheld lets inspectors record and report at the point of work. That is the design intent, and the device remains subject to certification and site approval.
There is no stock to order for Italy yet. The IS-04Z1 is pre-launch, certification is in progress, and supply will run through authorised distributors after the certificates are issued. Procurement teams can prepare now with the datasheet, the certification schedule and a safe-area evaluation.
The technical specification, marking target and conditions of use, sent by email.
Which certificates are in progress, in what order, and what is still to be confirmed.
Evaluation units can be used for connectivity, MDM enrolment and workflow testing outside classified areas.
Tell us the site, zone, gas group and quantity so the right authorised distributor can contact you.
No. Nothing can be bought or taken into a classified area today: certification is in progress and launch is planned for Q4 2026. What is available now is the datasheet, the written certification schedule and evaluation units for safe-area use.
There is no list price yet. SAMS gives indicative pre-launch pricing in writing, against a stated quantity and site, and does not commit to a lead time before certification completes.
The circuits are designed to limit energy so a spark or hot surface cannot ignite a gas or dust atmosphere, even with one fault (level ib, Zone 1). Certification of that design is in progress.
The market guide for Italy covers Priolo, Melilli and Augusta, Gela, Milazzo, Sarroch, among others. Site-level pages are linked below.
Through authorised distributors once certificates exist. Until then SAMS can send the datasheet and certification schedule and arrange safe-area evaluation units.
Italy applies ATEX Directive 2014/34/EU as an EU member, and employers zone workplaces under Directive 1999/92/EC. Devices for Zone 1 and Zone 2 should carry CE and Ex markings with Italian-language instructions where required. Operators usually add their own approval and permit procedures.
The Val d'Agri area in Basilicata hosts the largest onshore hydrocarbon field in Europe, and the Po Valley and offshore Adriatic hold moderate gas reserves. Refineries, fuel terminals and gas stations add downstream sites. Confirm site lists with the operator.
The market guide says teams can test a unit through a fermata while certification runs. Trial terms and site access are set by the plant operator, and a unit would need to be accepted for the zones it enters. Ask the operator's HSE team before arranging a trial.
More on Italy, and on other places in Italy.
Tell us what you need to equip and where. The SAMS team answers by email with the datasheet and where each certification route stands.
Send the zone and gas group of your site and we will reply with the datasheet and schedule.