United States: rules and approvals
US workplace rules accept electrical equipment in explosive atmospheres only if it is approved by an OSHA-recognised NRTL, and OSHA states that the NRTL's specific mark is required, so CE and ATEX do not count.
The IS-04Z1 is built for people who work inside classified locations at American refineries, gas plants, terminals and wellsites, and for the HSE and IT teams who decide what goes through the gate. The Permian also yields potash, mined by the room-and-pillar method in Lea and Eddy counties in New Mexico, which adds mining and mineral-dust hazards to the oil and gas activity. Distribution partners for United States are being identified ahead of the Q4 2026 launch of the IS-04Z1.
Pre-launch · certification in progress · Launching Q4 2026
Short answer. United States has no appointed SAMS distributor yet: the IS-04Z1 is pre-launch (certification in progress, no certificate issued, launch planned for Q4 2026), and distributor applications are open.
Current position: certification in progress, nothing issued, launch targeted for Q4 2026. Operator approval runs on its own timeline. Certification status. Place facts reviewed October 2026.
| Check | What to look for | IS-04Z1 today |
|---|---|---|
| Ex marking | Group, category, protection concept, gas group, temperature class | II 2 G Ex ib IIC T4 (target) |
| Gas group | IIA, IIB or IIC matched to the area drawing | IIC (target) |
| Temperature class | T-class below the ignition temperature of the gas | T4, 135 °C (target) |
| Where it applies | United States: Beaumont and Port Arthur, Lake Charles and Calcasieu, Baton Rouge corridor | Classified by the site operator |

An intrinsically safe Android smartphone designed for Zone 1 and Zone 21 hazardous areas in United States. It is pre-launch: IECEx, ATEX and NEC 500 certification is in progress ahead of the Q4 2026 launch.
The main operators, industrial areas and sites that the SAMS United States market guide covers.
US workplace rules accept electrical equipment in explosive atmospheres only if it is approved by an OSHA-recognised NRTL, and OSHA states that the NRTL's specific mark is required, so CE and ATEX do not count.
For Zone approval the ANSI/UL and ANSI/ISA 60079 series apply, and ordinary-location electrical safety standards such as ANSI/UL 61010 must also be met.
The Permian Basin in West Texas and south-eastern New Mexico covers more than 86,000 square miles and extends about 250 miles wide and 300 miles long, so sites are spread over a very large area.
The Permian is the highest-producing US oil field, averaging 4.2 million barrels of crude a day in 2019, with Midland, Odessa and San Angelo serving as headquarters towns.
“Ex-proof” is shorthand for equipment carrying an explosion-protection marking (the Ex mark) that matches the area it enters. The marking states the protection concept, gas or dust group and temperature class, and it must be backed by a certificate issued by a recognised body, so a phone described as Ex-proof should come with a certificate number you can check.
The IS-04Z1 is designed to carry the marking II 2 G Ex ib IIC T4. That is a target: certification is in progress, no certificate has been issued, and SAMS will publish the certificate numbers when they exist.
In United States. A US marking check reads the ATEX target II 2 G Ex ib IIC T4 and the Class I Division 1 listing pursued on the same basis. IIC maps to NEC Groups A and B, above Group D. Combustible dust at sulfur handling, coal transfer and solids charging is read against Zone 21 and Class II.
SAMS is appointing authorised distributors ahead of the Q4 2026 launch. No territory has been granted for United States yet and applications are reviewed company by company. Because a certified Ex device cannot be opened by an ordinary phone workshop without invalidating its certificate, SAMS looks for partners who can provide competent technical support and after-sales service locally.
No. Nothing can be bought or taken into a classified area today: certification is in progress and launch is planned for Q4 2026. What is available now is the datasheet, the written certification schedule and evaluation units for safe-area use.
SAMS has not published a price. Any figure you are offered for an uncertified Ex phone should be treated with caution; written indicative pricing is available for a defined quantity and site.
The marking target is II 2 G Ex ib IIC T4. It becomes a marking only when the certificate is issued; until then it is a design target.
The market guide for United States covers Permian Basin, Houston Ship Channel, Beaumont and Port Arthur, Lake Charles and Calcasieu, among others. Site-level pages are linked below.
Apply through the distributor page with your company details and the territory you cover. SAMS reviews applications company by company and has not yet granted a territory for United States.
Not on its own. US workplace rules accept equipment approved by an OSHA-recognised NRTL and marked accordingly, and ATEX or IECEx certificates are not accepted in their place. Manufacturers usually need a separate US listing, so check the NRTL mark and the Class, Division or Zone marking on any device.
Both exist. Article 500 of the National Electrical Code defines the Class and Division system, and Articles 505 and 506 define Zones. Many existing refineries and gas plants are still classified by Division, so confirm which system the area drawing uses before selecting equipment markings.
IP68 sealing and a rugged build are aimed at August heat and January cold, and the 4,000 mAh battery at a shift away from the truck. The approved ambient range will come from the certificate, which is in progress, so confirm it for both extremes.
Other guides for United States, other places in United States, and the pages behind them.
Share the site details and quantity. You will get the datasheet and the certification schedule back by email; pricing is indicative only until launch.
Name the site and the operator and we will send what is available before launch.